This Bracket has been designed for fast and easy dismount and remount when filling is needed, just pull 2 ring pins, NO TOOLS NEEDED! When the pins are pulled, grab the built in handle and go! The mount has been designed to adjust the angle of the bottle from 0 to 20 degrees with the location of the front pin. DynoTune recommends 15 degrees but in some tight areas it's hard to get that angle. When the pins are in the front and rear holes the bottle is at 0 degrees. For every hole you move the front pin back it will tilt the bottle up 5 degrees.

With this Bottle Bracket, the worry of scratching and scuffing your bottle is gone, mount it once in the clamp rings and it's done! This bracket is brand new, fresh off the CNC Machining Center! The Brackets fit standard 7" bottles like DynoTune, Edelbrock, ZEX, NX, Venom and NOS (standard 10lb bottles). The quality is incredable

This new Switch will accept an input rpm signal from a coil negative terminal (for stock ignitions), a tach output from an ignition control, an ECU tach output or even a 5 volt tach signal. Another great feature is that no rpm modules are needed! The rpm activation points are programmed by simply scrolling through the LED display to your desired rpm amounts. The Switch has two outputs; one Normally Open, the other is Normally Closed.

It can be programmed from 200 rpm to 15,000 rpm in 100 rpm increments. It can be used with an input voltage of 9 - 18 volts.